Dual Build plate dock for Ace 2 Pro Riser

Works with my Ace 2 Pro Riser Design for the Anycubic Kobra 4. Please see the link "https://www.makeronline.com/en/model/Anycubic%20ACE%202%20Pro%20Riser%20Shelf%20for%20the%20Kobra%204/343401.html?trackModuleType=10"

Description:

Stop stacking your build plates on the desk. This dock holds two 270 × 270 mm spring-steel plates upright, protected and always within reach, and it hangs right on the rear legs of your riser.

Why you’ll like it

• Holds 2 plates, each held on three edges by guard slots and a base groove, so thin sheets can’t bow or fall
• Drops onto the dovetail rails, with no tools and no screws
• Doubles as a leg brace, so it stiffens the riser too
• Pinstripe and rounded details to match the rest of the riser
• Prints in 3 parts that fit a 260 mm bed

Specs

• Plates up to 270 × 270 mm, 1 mm clearance each side
• Slots are 2.4 mm wide, so they take 0.4–1.2 mm sheets

Print

• 2 × halves and 1 × coupler, standing up, no supports

Assembly

1. Remove the original leg brace of the model.
2. Drop a half onto each inner leg rail.
3. Press the coupler between them. It’s a firm fit, so tap it in with a soft mallet.
4. Drop the plates in from the top, tab edge up.
5. Make sure it clears the power cord going to the hot bed.