GYM - SQUAT MAN FIGURE / TROPHY

SQUAT MAN FIGURE

Instruction:

• Print Plate n.1;
• Remove Support;
• Print Plate n.3;
• Stick the Squatman on the base with glue;
• Print Plate n.2;
• Stick the disk in couple back to back;
• Print Plate n.4;
• Stick “stop” on the disk and stick all to the bar;
• The distance from the stop to the end of the bar will be the same of the opposite side;
• Insert the bar through first hand, pass behind the neck, in the appropriate location, in the end insert the bar in the another hand;
• Stick “stop” on another disk couple;
• Stick all on the bar leaving the same distance left before on the other side.

P.S.: In photo the base is signed “essenza”, in model the base is blank.