Ergonomic Elevated Dual Pet Bowl Stand

A sleek, modern, and sturdy elevated bowl riser designed for cats, puppies, and small dogs. Raising the feeding station promotes a more natural neck posture during eating and drinking, helping to improve digestion and reduce neck strain.

The design incorporates a lightweight honeycomb grid between the bowl cutouts, saving filament while adding a clean, modern aesthetic.

Key Features

• Ergonomic Eating Angle: Elevates water and food to reduce stress on your pet's neck, joints, and spine.
• Modern Honeycomb Lattice: Center hexagonal pattern saves print time and material without sacrificing structural strength.
• Arch Cutouts: Side and front arched cutouts make picking up, moving, and cleaning underneath effortless.
• 100% Scalable: Need a larger or smaller bowl size? Uniformly scale the model in your slicer (X/Y/Z) to match your custom stainless steel or ceramic pet bowls.
• Default Inner Ring Diameter: Designed to fit standard ~115–120 mm (outer lip ~130–135 mm) pet bowls at 100% scale.

💡 Sizing & Scaling Guide

If your bowls have a different rim diameter:

1. Measure the outer diameter of your bowl below the rim (the diameter of the hole needed).
2. Divide your measured bowl diameter by the model's hole diameter (~118 mm) and multiply by 100 to get your scale percentage in Bambu Studio / OrcaSlicer.

• Example: If your bowl needs a 140 mm hole: (140 / 118) * 100 = ~118.6% scale.

Print Settings

ParameterRecommended SettingMaterial:PETG (preferred for water resistance, easy washing, and durability) or PLALayer Height:0.20 mm (Standard)Walls / Perimeters:3 to 4 (recommended for rigid side legs)Infill Density:15%Infill Pattern:GyroidSupports:None (print upside down / top face flat on the build plate as sliced)Brim:Not needed on textured PEI plates

Print Profile Description (pro tiskový profil)

Tested & Optimized Print Profile for Bambu Lab Printers:

• Layer Height: 0.20 mm Standard
• Filament: PETG (recommended for moisture resistance and food/water splatter)
• Infill: 15% Gyroid
• Walls: 3 perimeters for solid structural legs
• Supports: None (orientated top face flat down on the plate for a smooth top finish)

Brim: use 5mm outer brim