Modular Rack Mount for UniFi UXG Max | UniFi UCG-Ultra | UniFi UCG-Max (19" version)
A modular 19-inch rack mount for the Unifi UCG-Ultra, UXG-Max, and UCG-Max lineup.
OBS.: The UCG-Max processor reaches 75~ 90 degrees Celsius for normal use, and the bottom can get REALLY HOT. So use filaments with higher temperature tolerance if that's your device.
This mount is part of a 19-inch modular rack mount system I designed, you can mix and match the modules with other mounts. Take a look at my models here to find out the other 19-inch mount modules.
Do you like my models? Consider buying me a coffee ;)
Parts
- 3x M5 screws (Min size: 12mm, recommended size: 16mm).
- 3x M5 hex nuts.
Assembly
OBS.: The modules used in this tutorial are only for illustration purposes, and I'm using it for the whole series. It might not reflect the models you download at this page.
- To assemble the parts, insert the 3 screws into the Right module.
- Then align it with the Left module.
- After that, insert the hex nuts in the screws, and using a screwdriver or allen key.
- Tighten the screws until you start feeling resistance and the nuts are securely into place. After that, you can install the mount in your rack.
Print Settings
Rafts:
Doesn't Matter.
Supports:
Yes.
Resolution:
0.2 or 0.24
Walls/Perimeters:
At least 3. Better with 4.
Infill:
20% or more
Filament:
PLA+/PETG/ABS/ASA/Nylon
