Heres a Darth Vader lamp I came up with and uses LED strip.

For the Vader Statue, do a filament swap at 1.4mm using 0.2mm layer height.

For the base it will need the AMS, if there is enough interest I will make a version that won't need it.

Assembly is basic, stick the LEDs to the base and run the cable out of the hole. I use SK6812 LEDs and a USB LED Driver with a remote for control. You could also use an ESP32/ESP8266 and run WLED. Glue the Saber Blader into the saber hilt with some CA/Super Glue.You may need to resize the saber to get a good fit.

If you don't want to white slots in the base to glow, just run a strip of something like aluminium foil to block the light, I suppose you could also paint the inside black.