A Bloom of Terror – Halloween Monster Rose in a Jack-o’-Lantern

Thank you all for your support. I'm always happy to hear your opinions and suggestions for new models. So please share them in the comments.

You can offer me a coffee and support my work here >>> https://ko-fi.com/drakeforge3d  If you like my work and want to support me, I appreciate any support. The website also includes a commercial license that allows you to sell all my existing models.

Something hungry is growing in the pumpkin patch! This monstrous rose bursts from a cracked jack-o’-lantern, opening its layered petals to reveal a wide mouth packed with oversized teeth. A twisted, thorny stem and curling leaves connect the hungry blossom to the grinning pumpkin below.

With two wicked grins in one decoration, this model brings playful horror to Halloween shelves, spooky tabletop displays, and fantasy collections. Display it in a single color or paint the pumpkin, petals, and teeth for an extra touch of Halloween character.

Printing information:

• Designed for FDM printing.
• Supports are required.
• Carefully remove supports inside the flower’s mouth, beneath the petals, and around the leaves.
• Take extra care around the teeth and thorn tips during cleanup.

   Guide

Each of my models is printed 2-3 times before releasing the profile. So if you have a problem with printing:

1. DRY THE FILAMENT

2. CHANGE THE NOZZLE TO A NEW ONE.

Recommendations Guide : In case of a problem with damage to the supports, I recommend reducing the printing speed of the supports by 30-50% and the travel speed to 400mm/s. When removing the supports, I recommend first cutting off the pieces right next to the character, but not removing them, just cutting them off. Remove the remaining larger pieces and only then detach the remaining smaller pieces. This reduces the risk of damaging delicate elements.

• Please note that if you use a different filament than the recommended one, the effect may be different from my print. For example, printing in silk PLA will look better but the supports and the print itself will be more brittle and less durable.
•  
•  
• Recommendations:
• 
  
•  
• 0.08-0.2. In the event of changing the original height, the height of the supports should be changed.
•  
• PLA+HS, PLA+, PLA, PLA silk Recommended materials are listed in order from best to good.
•  
• Clean the plate thoroughly before printing.
• Make sure the filament is dry and free from dirt. This can damage the print or weaken the support