Creality Suspended String Lamp

This suspended string lamp has a meditating Creality mascot floating in the center of a cylinder of tightly strung vertical lines, which gives it a levitating look. The LED lighting at the top and bottom washes the strings in color and lets the whole thing glow in changing shades through a remote. It makes a calm, eye-catching accent for a desk, shelf, or nightstand.

Boost Me

ty

Boost

You will need 2x AAA RGBW pucks, either from bambulab or aliexpress.

You may want to print a test model with one color only to make sure your printer can pull it off before trying the full color model. Its normal if a few strins fail, simply snip them off and you will barely notice it.

Do not use cool plates. When you finish printing, LET IT COOL! If you try to pull it off while it is hot, the strings will bend. The plate needs to be cold and the print will pop off without issues.

Most models with strings only use a single 0.24 layer high string, I use two. That way, if one fails, the other usually does not. you also need to have proper adhesion, clean your plate and watch the print so you get the best results possible.

To light it you will need the standard 3AAA RGBW pucks from aliexpress, two in total.

Relatively simple, assemble the two halves using an assembly jig in the profile, it is basically two rings that will fit exactly to the two halves, just make sure you put a paper down so the glue doesn't leak and ruin your table (ask me how I know). There are nubs in the provided bases and it will keep it in place for a desktop stand, but carrying it around without gluing it, is not advised… if you are happy with it and do not wish to reuse the base for my other models, go ahead and glue it.

Also, DO NOT change layer size because then the strings may fail. Any issues, let me know.