Dinosaur Costume Kid Keychain

Dino Hoodie Kid Keychain: 4-Colour Multi-Material Print

A cheerful kid in a dinosaur hoodie, giving you a big thumbs up. It's a flat, enamel-pin-style keychain: all four colours print on one smooth top surface, with a recessed white border around the outside.

Features

• 4 colours: white, black, a hoodie colour and an accent colour for the spikes, pocket and cheeks. Shown here in bright green with pink accents; yellow accents look great too.
• Flush multi-colour face, so the design is smooth to the touch
• Recessed white border frames the design
• Built-in key-ring loop with a 4.5 mm hole, fits standard split rings

Size: about 42 × 80 × 3.7 mm

Print settings

• Printer: multi-colour printer required (AMS, ACE or similar), since there are several colours per layer. Printed on an Anycubic Kobra X.
• Material: PLA, same material for all four colours
• Layer height: 0.2 mm, or 0.12 mm for crisper details
• Supports: none. Print flat, face up.
• Infill: 15%

How to load

1. Open the 3MF, or import all four STLs together and choose "Yes" to load them as one object with multiple parts.
2. Assign each part to a filament slot: white (base, face, teeth and laces), black, hoodie colour and accent colour.
3. Slice and print. Colour changes only start above 2.5 mm, so the base prints quickly in one colour.

Tips

• The hoodie strings, shoelaces and eye shine are the smallest details, so check them in the slicer preview.
• If you see fine strings on the edges, raise retraction slightly for your white filament, or clean them off with a quick pass of a heat gun.