Kobra S1 ACE pro Riser & IKEA pegboard / Kobra S1 ACE pro 增高&宜家洞洞板模块

6月25日根据反馈优化了部分模型问题：

1、洞洞板侧板厚度4.8mm预留公差过大导致通用挂件太松，现改至5mm厚，通用挂件更紧固

2、主体侧板设计了悬垂支撑，降低悬垂塌陷风险

3、原模型和打印配置文件均已更新

在原作者模型基础上镂空了侧面，并增加了洞洞板模块。

1、侧面镂空中间挖空：保留强度同时减少耗材使用量，缩短打印时间；

2、增加宜家洞洞板侧板：增加实用性，可拓展更多挂件。

打印注意：

打印不需设置支撑，PLA/PETG/ABS/ASA均可打印

On June 25th, some model issues were optimized based on feedback:

1. The reserved tolerance for the thickness of the side plate of the pegboard being 4.8mm was too large, resulting in the universal hanging parts being too loose. Now it has been changed to 5mm thick, making the universal hanging parts more secure.

2. A hanging support was designed for the main body side plate to reduce the risk of hanging collapse.

3. Both the original model and the printing profile have been updated.

On the basis of the original author's model, the sides were hollowed out, and a pegboard module was added.

1. The middle of the hollowed - out side is excavated: This retains the strength while reducing the consumption of printing materials and shortening the printing time.

2. Add IKEA pegboard side panels: This increases the practicality and allows for the expansion of more hanging items.

Printing notes:

Support is not required for printing. PLA/PETG/ABS/ASA can all be used for printing.