Knit Cat Pumpkin Kit: bead, charm, light cover, keychain, magnet

A knitted jack o lantern pumpkin with little cat ears, in 5 versions in one kit. Original design by Tasty Voxels, made by me with my Regolith Highfield tools (not AI generated).

WHAT IS IN THE KIT

Bead, 15 mm: for a cord or an elastic bracelet.

XL hole bead, 15 mm: bigger hole for thicker cords and charm bracelets.

Light cover, 25 mm: hollow with an open base, it goes over a mini LED tea light.

Keychain, 35 mm: twisted loop for a split ring.

Magnet, 35 mm: two halves with a pocket for a round magnet. One half alone is a fridge magnet. The two halves together clip a small light curtain or a small bow.

ALSO A JEWEL

Print the keychain small, about 15 mm, and it becomes a necklace pendant, an earring or a charm: add a jump ring and a chain or an ear wire. The beads go on bracelets.

PHOTOS

The real photos show my test prints of the cat pumpkins. The renders show the files of the kit and how to use them.

PRINT SETTINGS

Each version has its own 3MF set up for the Anycubic Kobra S1 with Anycubic PLA in two colours: orange for the pumpkin, green for the ears and the loop. 0.2 mm layers. Tree supports only from the build plate where they are needed; the beads use supports on critical overhangs only, so nothing grows inside them. The magnet halves print without supports. Glitter or silk filaments look lovely too. Raw files: a plain 3MF with colours for every version (it opens in any slicer) and the STL of the beads and of the magnet halves. The STL of the light cover and of the keychain are not included here because they are too big for my upload: use their plain 3MF instead, it holds the same geometry.

LICENSE

Personal use only, non commercial.

COLLECT THEM ALL

This kit is part of a whole pumpkin family: the classic Knit Pumpkin Kit, the Jumping Pumpkin, Pumpktobat, the Cutest Pumpkin Puzzle and more. Find them all on my profile!