Kobra 3 Printhead ( Front piece)

I attempted making the Anycubic Kobra 3 printhead using AutoDesk Inventor

The model is not perfect but it seems work hope you guys like it

the support is kinda tough to take off i recommend using cutter or metal scraper to peel it off

Recommendation

layerheight 0.2

Support normal ;on build plate only

print with the logo faced down

Instruction

Carefully take out the components

take out the fan unscrewing two of the scew

the led part can be taken out with flat head screw driver by pushing the right side of the circuit board and slowy shove it up

put the component in the printed printhead

make sure to align the wire through the bracket on the left side

****Dont forget to print at least 2 of the supportthingy.stl it need to be attach to the top portion of the model as seen in the picture as red part.

*****as tested it will be tight fit if u slide it in

Coloring

the logo part of the stl can be colored using fill.

if you point the cursor near the logo part you will see the outline

or else just fill the entire part with the setting edge detection off and you will see the logo

Notice

Do this at your own risk

Related models

Cat ears https://www.makeronline.com/model/Cat%20ears%20for%20Anycubic%20Kobra%203%20printhead/29299.html

please dont steal mywork ;-;;;;