Compact Powerbank (light weight carry)

This is a Casing for 18650 battery with a board for active charging and discharging. (A Single battery power bank).

Bill of Materials:

- Charging board

https://aliexpress.com/item/1005006087510671.html

- Contact plates 12 x 12mm

https://aliexpress.com/item/1005004640030928.html

Specs:

- Input power 5 Volts DC (USB - C).

- Output Power 5 Volts DC 1 Amp (USB - A).

- Light weight for easy carry.

Uses:

- Perfect for outdoor use and quick camping.

- Can be used to power anything that requires 5 volts.

- Can charge you phone (on slow charge mode) turn off the phone for more effective charging.

- You can use it a single18650 battery charger.

Cautions:

- Do not use old or untrusted battaries.

- Make sure you connected the leads correctly (the lead with the spring is the negative ( - ) side).

- Soldering is required please ask assitance from someone with experience.

Before you print:

- print plate should be cleaned with soapy water or IPA.

- machine should be properly maintained and lubricated.

- machine should be pre calibrated, Auto bed level, and pressure advance.

- Filament Flow rate should calibrated.

- Filament temperature should be optimized.

- Support filament materials is recommended (as i do most of my prints using support material filament for clean layers and easier support removal)